Voice Changer Software

In the Record section:

- The sample voice which was just imported is displayed in the Voice section (6).

- To re-listen to the sample voice, click the Play (7) button.

- In the Morpher section, click the Rec (1) button to to start recording your voice. Try to mimic the sample voice over its tone, speed, rhythm and volume.

Note: If you receive an error message saying that "Cannot make comparison. Please, try to record your voice again," it might because you spoke too low or too fast that VCS Comparator couldn't detect the voice. Close the message and record your voice again.

You can click on the Play (2) button to re-listen to your newly recorded voice.

- The Comparator message (3) is now showing how similar your voice and the sample voice are.

Tip: You can adjust the Timbre, Pitch and Adv. Tune sliders (Advanced tune) to make your recorded voice sound more alike to the sample voice yourself, then click the Compare (4) button to get the comparison result. However, it is recommended that you leave the settings alone and keep following the next step.

Fig 3 - Record your voice [Comparator]

- Click the Auto button (5)  (see fig 4), VCS Comparator will automatically compare the two voices and then suggest the best settings in Pitch, Timbre & Adv. Tune that make your voice sound most alike to the sample female voice.

- Click OK to close the Comparator and return to the main panel. The suggested settings will be applied to the Voice Morpher module.

- Speak to the microphone to check if the result voice is what you want or not. If you are satisfied with it, you've done.

If you are not, try adjusting slightly the pitch and timbre to see if you can get a better result. If you are still not pleased, go to step 5.

Fig 5 - VCS Comparator is doing the automatic comparing process [Comparator]

- Click the Advanced button to expand the Advanced panel.

- Select the Equalizer tab, turn it ON (1), click on the Preset button (2) and select Gentle.

Tip: In most cases, the Gentle preset works well. But if it does not, try the other ones or load your own settings. You can click the Reset command to discard the changes made by the preset.

TOP
 

Fig 6 - Choose the Gentle preset [Equalizer tab]

If you feel that the output voice has background noise, follow this step to eliminate them. But firstly, you are recommended to save your current morphing settings, click the Save button on the Voice Morpher module on the main panel to save them. The saved file will keep all the settings that are being applied in VCS.

Get back to the Advanced panel:

- Select the Sound Quality tab, turn it ON (1), turn on the Limiter module (2), turn on the Noise Reduction module (3), then slightly adjust these parameters: Release, Attack, Reduction, and Threshold until the noise is less dominance.

TOP

Fig 7 - Improve the output quality [Sound Quality tab]